Complete Refinishing

Member of the

National

Wood

 Flooring

Association

Wood floors that meet any of the following conditions, will need to be completely refinished:

Going the extra mile...or shall we say the extra "cut"

We are proud to have developed a 5 step (5 cut) sanding system that is the foundation of a quality finished floor.  The 5 cuts refer to the progression of sanding sequences from rough to super fine.  Often, when consumers get a low price quote on floor refinishing it is based on 2-3 cut sandings only.  Reducing the amount of sanding cuts from 5 to 2 or 3 certainly provides an opportunity to save time and labor, it is certainly not to be preferred by the quality conscious consumer.  Fewer cuts of sanding leaves the wood pores too open resulting in most of the finish penetrating into the wood.  It is difficult to achieve sufficient film build up of the finish this way.  The 5-cut sanding system's additional cuts of fine sanding provides the solution.  By following up the initial cuts with a fine and super fine sanding, we close the pores of the wood so much, that the finish stays on TOP of the floor instead of soaking into the wood.  This gives you a superior finish build up which translates to a superior looking and wearing floor.